Type and application
The following types of Disconnectors are used in substations depending on the site-specific requirement,
- Horizontal Centre Break
- Horizontal Double Break
- Vertical Break
Horizontal Centre Break / Horizontal Double Break
These types of the disconnectors are used in the normal height of the bus to transfer the current to the other equipments in the bay and will function as a no load switch. This will be installed in incoming and outgoing sides of the distribution equipment according to the substation bay requirement. This will be operated in conjunction with the Circuit breaker for any switching on / off and maintenance purpose.
Earthing switches shall be provided in the disconnectors based on the requirement and for earthing purposes. The earthing switches will be closed when the disconnector is in off condition and vice versa for earthing the induced current and voltages on the busbar when the circuit is open condition / maintenance purpose. This also will take care of the short circuit current when the main disconnector is in open condition.
The disconnectors are normally horizontal upright mounted. In case to bring the bus from the gantry and to meet busbar configuration, either under hung type or vertical type shall be used.
The Pantograph type disconnectors are used for current transfer / coupling of buses at two different heights. Through the pantograph, current will be transferred from the top-level buses from the transmission side to the normal level bus in the substation.